Weber L is a polymer-modified base coat for dry indoor spaces. Weber L is designed for use as a base coat under fine-grained finishing plaster, as well as under wallpaper and textured paint. Suitable for skimming gypsum and wood-based panels, as well as gypsum and cement-based plasters. Mixing with water produces a ready-to-use skim coat.
• Coverage: approx. 1.2 kg/m²/1 mm
• Application temperature: at least +10°C
• Shelf life: 18 months (in dry conditions, in the original sealed packaging)
• Drying time (touch-dry): 1–2 days, depending on layer thickness, temperature, and ventilation
• Mix layer thickness: 1–3 mm for full leveling; partial leveling up to 5 mm
• Water content when mixing: 7 l/25 kg
• Binder: polymer adhesive
• Filler: limestone powder, particle size < 0.6 mm
• Pot life: 2–3 days when ready-mixed in a sealed container
• Color: white
Surface preparation: Suitable substrates include cement-based plasters and fillers (e.g., Weber TT), gypsum surfaces, and concrete, lightweight concrete, and brick structures. The substrate must be clean, solid, and free of dust—remove any substances that could impair adhesion, such as paint, grease, and dust.
Mixing: Mix one bag of dry mix with 7 L of clean water at room temperature. Mix twice with a whisk attached to a drill—the first mixing (about 1 minute) is done with less water, then let the mixture stand for 15 minutes, then mix lightly a second time (about ½ minute) and add the remaining water. The pot life of the prepared mixture after adding water is 2 days (in a sealed container). During application, the temperature of the substrate, the mixture, and the room must be above +10°C.
Application: The mixture is applied to the surface either mechanically or by hand using a trowel. For spot patching, use a trowel approximately 30 cm wide; for full-surface patching, use an 80 cm wide trowel. Excess mixture is removed from the trowel into the mixing bucket and reused later. Before applying the next coat, the previous coat must be completely dry. Sand each coat with fine-grit sandpaper.
Surface Finishing: A surface filled with Weber L can be wallpapered or coated with textured paint. To achieve a smoother finish, the surface must be finished with a fine finishing compound, such as Weber LR Fine or Weber LR+.
Cleaning Tools: Wash tools with water immediately after use. Avoid allowing mixture residues to enter the sewer system.
Safety Precautions: Avoid inhaling dust and contact with eyes. Irritates the eyes, respiratory tract, and skin. In case of skin irritation, wash immediately with warm soapy water. If the mixture comes into contact with the eyes, rinse immediately with water and seek medical attention if necessary. If necessary, use safety goggles, a respirator, gloves, or protective cream.