Knauf Uniflott is a gypsum-based joint compound for manually filling joints in gypsum board during interior work. The joint compound is a powdered dry mix based on special gypsum, modified with polymers and adapted for use with mineral fillers, which is mixed with water before use. The joint compound has high crack resistance and is very easy to apply to joints thanks to its smooth, cream-like consistency. In addition, the joint compound has a fast setting time and a short drying time, and it can be easily sanded with Knauf Abranet sanding mesh. Material consumption is approximately 250 g per 1 m of joint.
Surface Preparation: The substrate must be stable, dry, clean, and even. Remove any existing layers that prevent adhesion, such as wallpaper adhesive or paper residue. Gypsum boards must be securely fastened to a load-bearing substructure and have clean, dust-free joints. Cut edges of the panels, as well as the Knauf Cleaneo SK edges, must be primed in advance with Knauf Tiefengrund.
Preparing the joint compound: Sprinkle Uniflott powder evenly into clean, cold water (up to 5 kg per 2.4 liters of water) until the water level is reached. Then mix with a trowel, without adding anything else, until a creamy consistency is achieved. From the moment the powder is added to the water, the working time is approximately 45 minutes until the mixture begins to set (at 20°C). Lower temperatures shorten the working time, while higher temperatures extend it. Dirty mixing containers and tools also shorten the working time. Do not reuse a plaster mixture that has begun to set.
Work Site Temperature and Conditions: Skimming may only be performed once the dimensions of the gypsum board surfaces no longer change significantly due to humidity and/or temperature. When pouring cement, composite, or cast floors, perform the joint filling only after the cast floor has dried. The room and substrate temperatures must not be lower than +10°C.
Joint Filling (Smooth Gypsum Board): As a rule, at least two passes are required. During the first pass, fill the joints and, if necessary, install joint tape. After the joint compound has dried, apply a second coat using a wider jointing trowel to achieve a smooth transition at the joints. Also fill in the areas around fasteners with joint compound. After the joint compound has dried, sand the surface, e.g., with a Knauf Abranet sanding mesh. Wash tools and the mixing container with water after use.
Storage: Store bags in a dry room on wooden pallets. Seal torn or damaged bags airtight and use them first. Shelf life: approximately 9 months.