Applications: For installing all types of ceramic and clinker tiles and natural stone on walls and floors, indoors and outdoors, in dry and damp areas. Particularly suitable for installing on heated floors, glass mosaics, thin semi-transparent tiles, marble, and similar materials. Substrate Type Walls and floors with moderate deformation, such as plastered masonry, stone walls, gypsum board, gypsum plaster, concrete elements, and lightweight concrete elements with moderate volume expansion. Substrate Preparation The substrate must be load-bearing, stable, free of cracks, and clean of dust, grease, and cement slurry. The surface must be dry enough for the Mira 4180 primer to be absorbed. When installing on old tiles or painted surfaces, ensure that the tiles and paint are firmly adhered. Clean the surface using Mira 7110 Base Cleaner. Prime absorbent surfaces with 4180 Primer, and make damp areas watertight in accordance with ETAG 022 regulations and Mira’s instructions. For best results, mix with a mixer. The powder, water, and substrate must be within the recommended working temperature range.
The tile mixture must be used within 6 hours after mixing.
It is not recommended to apply the mixture to large surfaces unless the tiles can be laid before a skin forms. Apply 3130 Superfix to the surface and spread it out with a trowel
with a straight edge, then comb it through with a notched trowel.
Select the trowel according to the tile type. Press the tiles into the wet mixture. Ensure that the back of the tile is completely covered with the mixture. Surfaces larger than 36 m² or with sides longer than 8 m are typically divided into separate work sections throughout the entire structure. Depending on the absorbency of the tiles and the room temperature, the surface will be ready for further treatment in approximately 10 hours on walls and 18 hours on floors.