Mira X-plan is a cement-based, polymer- and fiber-reinforced, fast-setting repair and leveling compound for floors in wet and dry areas. Suitable for pouring a leveling layer on substrates with a slight risk of deformation, including concrete, screed, lightweight concrete, wood, tile, paint, as well as on joists and heated floors. A dry mix that is ready for use after mixing with water. Self-leveling and easy to smooth.
Applications
: For creating slopes and pouring leveling layers in wet and dry rooms, and for covering floor heating cables. Can be applied by hand or pumped.
Substrate
:
On concrete, leveling screed, and paint, a layer thickness of 2–50 mm is recommended; on lightweight concrete, 5–30 mm; on wood, 5–50 mm; cover heating cables with a layer of at least 5–10 mm, depending on the cable’s power rating and the stability of the substrate. On wood or heated floors, use Mira Uninet reinforcement mesh.
Substrate Preparation
The substrate must be dry, sound, and free of grease, dust, and other contaminants. Remove cement slurry, loose particles, and weak spots, and repair the surface. Use Mira 7110 Base Cleaner for cleaning.
Priming
On concrete surfaces, use Mira 4180 Primer; dilute with 1–3 parts water depending on the porosity of the concrete. Prime wooden surfaces with undiluted 4180 primer. On non-porous surfaces, use 4140 Contact Primer. Apply the primer to the surface with a brush and rub it in; when pouring in multiple layers, reapply the primer to the surface each time.
Application
:
Mix 25 kg of powder with 3.8–4.5 liters of clean water. To create a slope, mix 25 kg of powder with 3.8 kg of clean water. For best results, use a mixer or pump for at least 2 minutes until the mixture is homogeneous. Check the flowability with a flow test. Place a test ring filled to the brim with the mixture on a smooth surface, remove the ring, allow the mixture to flow freely, and measure the diameter. Self-leveling; use a trowel to assist the flow in the corners. When creating slopes, pour the mixture onto the higher part of the floor and let it flow toward the drain. Secure mira planstop self-adhesive foam strips around the drain opening. The floor slope can be adjusted while the mixture is setting. Depending on room temperature and humidity, the surface is ready for light traffic after 2–3 hours. Further surface treatment can begin after 6 hours. In wet areas, apply the Mira 4400 Multicoat system as a waterproofing barrier after 12–18 hours.
• Layer thickness: 2–50 mm•
Coverage: 1.7 kg/m² per 1 mm layer•
Working time: 15–20 min•
Processing time: 30 min•
Recommended application temperature:
10–20 °C• Drying time: 2–3 h for light loads, 6 h for further processing