Mira 5300 Netfix Fiberplaster is a flexible, gray, cement-based, fiber-reinforced adhesive and reinforcing plaster for bonding and reinforcing polystyrene boards, mineral fiber insulation boards, and mineral fiber lamella boards. A water-mixable dry mortar for reinforcing thermal insulation materials (such as facade polystyrene panels and facade mineral wool panels) with glass fiber mesh in the Mira Uninet facade insulation system (SILS). Suitable for reinforcing and skimming other substrates such as concrete, masonry, lightweight concrete, and aerated concrete. Suitable for use in Miratherm thermal insulation composite systems (SILS) as a reinforcing skim coat and also as an adhesive.
Applications:
A
flexible, gray, cement-based, fiber-reinforced adhesive and reinforcing mixture designed for bonding and reinforcing polystyrene boards, mineral wool insulation boards, and mineral wool lamella boards.
Suitable for interior applications, including wet and dry rooms.
Substrate Preparation
:
The surface of polystyrene boards and mineral wool boards must be level. Sand as necessary and remove dust.
Mineral substrates must be stable, dense, dry, and free of dust, grease, cement slurry, oil, etc.
Salts, mold, algae, and other factors that impair adhesion must be removed or treated in advance. Weaker sections of the substrate must be removed and repaired. Absorbent surfaces must be primed with the deep-penetrating primer mira 5050 tiefgrund; the remaining surfaces must be moistened while applying mira 5300 netfix. To reinforce mineral surfaces, the surface must first be plastered smooth.
Mixing
:
Mix the adhesive mixture in the following ratio: approximately 0.25 L of clean water per 1 kg of dry mix. Let the mixture stand for 10 minutes, then mix thoroughly. The mixture is now ready for use. For best results, mix using a low-speed mixer.
Application
:
Cover the insulation boards with Mira 5300 Netfix using a notched trowel, then press the reinforcement mesh into the mixture with at least a 10 cm overlap relative to the adjacent panel. Level the surface. The fiberglass mesh must not be visible through the mortar. Apply wet-on-wet; total layer thickness 3–4 mm. Before reinforcing the entire surface, use Mira 5300 Netfix to create the necessary diagonal reinforcements at open corners and to reinforce the corners and window jamb profiles.
Temperature
:
The minimum air and substrate temperature is +6°C. Avoid excessively high temperatures and direct sunlight.
Pot Life
:
After mixing, the Mira 5300 Netfix mixture remains workable for 2–3 hours. mira 5300 netfix is not recommended for application to large surfaces unless the surface can be reinforced or filled before a “skin” forms on the mixture’s surface, i.e., after 20–30 minutes.
Drying
Time
: The adhesive mixture is dry after 2–3 days; drying time depends on temperature, wind, and humidity. Cold and humid weather prolongs the drying time. During the drying period, protect the surface from precipitation and freezing.
Once dry, the surface is ready for the next stages of work using the following products: mira 5370 kratz, mira 5360 reibe, mira 5380 decora kratz, Mira 5400 Decora Reibe, Mira 5460 Silikat Reibe, Mira 5470 Silikat Kratz, Mira 5560 Reibe, and Mira 5570 Kratz.