Sadolin Maxi Base is a ready-to-use primer for interior use. The product has excellent filling properties, allowing it to fill holes up to 30 mm deep in a single coat without cracking as it dries. It adheres strongly to various types of stone surfaces. The putty is easy to apply, works well, and is easy to sand. Suitable for filling plaster, concrete, lightweight concrete, and brick surfaces, as well as gypsum board, for interior use in dry rooms.
• Application: dry indoor areas
• Binder: copolymer latex
• Particle size: < 0.3 mm
• Drying time: (23°C, 65% RH) 2–3 hours for a 1 mm layer of filler
• Thinner: water
• Color: light gray
• Application tool: putty knife
• Cleaning tools: with water immediately after use
• Storage: store in a sealed container in a dry and cool place (above +5°C)
Surface preparation: The substrate must be dry and free of dust, dirt, and grease. Use lukewarm or warm water to clean the surface; for heavily soiled surfaces, also use Cleaner. Remove old, loose paint and weakly bonded surface layers down to a solid substrate. If the surface was previously coated with glossy paint, sand it with sandpaper to ensure better adhesion.
Filling: Apply Maxi Base filler to the surface in one or more layers up to 30 mm thick. Before applying the next layer of filler, ensure that the previous layer has dried. Smooth the fresh filler as evenly as possible on the surface to minimize the amount of sanding required later. Reinforce joints and wider cracks with paper or fiberglass tape. Use medium- or fine-grit sandpaper to sand the filled surface. After sanding, carefully remove all sanding dust from the surface. Maxi Base filler is ready to use. After prolonged storage, the putty may need to be stirred lightly. Do not mix other types of putty or dry mixes into the putty. Latex, alkyd, and acrylic paints are all suitable for painting over the puttied surface.
Cleaning: Remove excess putty from tools immediately after finishing work; wash with water.
Storage: Store in a sealed container in a dry and cool place (above +5°C).
Health and Safety Precautions: When applying the putty and sanding the surface, follow all safety precautions; use a respirator, wear eye or face protection, and ensure the work area is well-ventilated. When finished, carefully seal the putty container. Remove excess putty before cleaning tools. Do not pour the product down the drain or into bodies of water. Dispose of liquid putty residues at a collection point for hazardous materials; only completely emptied containers should be sent for waste disposal.