Sadolin Maxi Aqua is a moisture-resistant, fine-grained lightweight putty. The product has excellent filling properties, is easy to apply, and works well, making it suitable for spot repairs, installing joint tape, and full-surface skimming of walls and ceilings. It adheres well to the substrate and dries quickly; the filled surface is easy to sand.
Maxi Aqua filler is part of a system that complies with the Swedish standard for damp rooms. Available in a wide range of packaging sizes. Suitable for filling plaster, concrete, lightweight concrete, and brick surfaces, as well as gypsum board and fiberglass wallpaper, for interior use in both wet and dry rooms. An effective solution for filling plasterboard joints and applying joint tape in bathrooms and shower rooms.
• Application: interior use in damp and dry rooms
• Binder: acrylic copolymer latex
• Particle size: <0.15 mm
• Drying time (23°C, 65% RH): 3 hours for a 1 mm layer of filler
• Thinner: water
• Color: light blue
• Application tool: putty knife
• Cleaning tools: with water immediately after use
• Storage: store in a sealed container in a dry and cool place (above +5°C)
Surface preparation: The substrate must be dry and free of dust, dirt, and grease. Use lukewarm or warm water to clean the surface; for heavily soiled surfaces, also use Cleaner. Remove mold and lime deposits from the surface with a damp brush or sponge, then wash the surface with Bio-Cleaner. Remove old, flaking paint and loosely bonded surface layers down to a solid substrate.
Filling: Apply Maxi Aqua filler to the surface in one or more layers up to 5 mm thick. Before applying the next layer of filler, make sure the previous layer has dried. Smooth the fresh putty on the surface as evenly as possible to minimize the amount of sanding required later. Reinforce joints and wider cracks with paper or fiberglass tape. Use fine-grit sandpaper (grit 150–180) to sand the filled surface. After sanding, carefully remove all sanding dust from the surface. Maxi Aqua Filler is ready to use. After prolonged storage, the putty may need to be stirred lightly. Do not mix other types of putty or dry mixes into the putty. Latex, alkyd, and acrylic paints are all suitable for painting over the puttied surface.
Cleaning: Remove excess putty from tools immediately after finishing work; wash with water.
Storage: Store in a sealed container in a dry and cool place (above +5°C).
Health and Safety Precautions: When applying the putty and sanding the surface, follow all safety precautions; use a respirator, wear eye or face protection, and ensure the work area is well-ventilated. When finished, carefully seal the putty container. Remove excess putty before cleaning tools. Do not pour the product down the drain or into bodies of water. Dispose of liquid putty residues at a collection point for hazardous materials; only completely emptied containers should be sent for waste disposal.