ISOVER RKL 31 is a rigid mineral wool board with tongue-and-groove joints along its longer sides and one side covered with glass fiber felt. Made of inorganic and chemically neutral material, it contains no components that cause corrosion. It is odorless, does not rot, and does not provide a favorable growth medium for mold. Meets the M1 pollution class for building materials. The product is installed with the glass fiber felt facing outward from the structure.
ISOVER RKL 31 is primarily used as a combined insulation and wind barrier board in exterior walls, attics, roof decks, and ventilated subfloors. The product is suitable for use in both new construction and renovation projects. Thanks to the tongue-and-groove joint, the panels fit tightly together (preventing thermal bridges).
The dimensions of the wool board are 1800 x 1200 x 30 mm. Each package contains 7 boards = 15.12 m².
Installation:
The joints between the wind barrier panels must remain impervious to ventilation air so that the ventilation air does not displace the air trapped between the wool fibers, which is what ensures the wool’s thermal insulation properties. ISOVER RKL 31 is installed on the studs using washers and nails or screws. The product is installed with the glass fiber felt facing outward from the structure. RKL Termofix installation kits are available for cold-bridge-free fastening of 75- and 100-mm-thick wind barrier boards. The wind barrier panels are installed so that the joints along their longer sides are perpendicular to the wood frame. This takes advantage of the tongue-and-groove joint, and the joints along the shorter sides of the panels align with the wood frame. To prevent the panels from being compressed, so-called spacer plugs corresponding to the thickness of the panels are placed under the spacer strips installed on top of the panels (inside the panels). The estimated consumption of spacer plugs or RKL Termofix fasteners is approximately 2.7 pcs/m² (based on a vertical spacing of 600 mm between the substructure and the framework). Fasteners are installed on the wooden subframe horizontally at a maximum spacing of 1000 mm. For example, a 3-meter-high wall requires 4 fasteners. RKL 31 wind barrier panels must not be taped, as the tape will not adhere to their surface; if it later falls off the panels, it may clog the ventilation channel, preventing airflow. To seal the joints, we recommend using a neutral construction sealant. The sealant bead should be 4–6 mm in diameter and applied to the edge of the wind barrier panel during installation.