Eskaro Fine Filler is a ready-to-use fine-grit filler for interior use. It adheres well to the substrate, dries quickly, and sands exceptionally well, creating a smooth finish. The product has good filling properties and is suitable for spot and full-surface filling in dry indoor environments. It is suitable for leveling small cracks, fissures, unevenness, screw heads, and other minor imperfections on walls and ceilings. Does not crack when applied in a 2 mm layer.
• Maximum layer thickness: 2 mm
• Maximum particle size: 0.15 mm
• Color: white
• Coverage: 1 m²/L for a 1 mm layer of full-surface application. Coverage depends on the application method and the substrate
• Solvent: water
• Drying time: A 1 mm layer dries in 2–4 hours at 20°C and 50% relative humidity. Drying time increases at lower temperatures, higher humidity, and with thicker layers.
• Tools: putty knife
• Cleaning tools: Remove dried putty from tools and wash them with water and soap immediately after application.
Surface preparation: The surface to be filled must be dry and free of loose or flaking material, grease, oil, dust, and other contaminants. If necessary, use Biotol E or Biotol Spray to remove mold. For filling cracks up to 10 mm wide, first use Face Filler, then finish with Fine Filler. Surfaces previously coated with enamel or oil-based paints should be sanded until matte. Prime porous, absorbent surfaces with Aquastop or Tiefgrund.
Filling: Apply the filler to the surface using a putty knife. Apply a second coat of filler after the first coat has completely dried. Sand the dried surface with fine-grit sandpaper (No. 150–180) until smooth. Carefully remove any sanding dust. Suitable conditions for filling are an air and surface temperature of +10...+25°C and relative humidity below 80%. Avoid drafts and high temperatures (above 25°C) during application. The filled surface can be painted or wallpapered after drying. Not suitable for damp rooms.
Storage: Store in the tightly sealed original container at a temperature of +5°C to +30°C. Protect from cold and direct sunlight.
Health and Safety Precautions: Wear a dust mask and safety goggles when sanding the filled surface. Avoid contact with skin and eyes. In case of contact with eyes, rinse thoroughly with water. Keep out of reach of children. Always handle paint products with care. Do not pour into sewers, waterways, or onto the ground. Avoid or minimize the generation of waste. Unused product is considered general waste but is not suitable for disposal with regular household waste and requires special handling; liquid residues must be handed over to a waste management company licensed to handle them.