Eskaro Aqua Filler is a ready-to-use, moisture-resistant fine-grit filler for interior and exterior use. It adheres well to the substrate and dries quickly; the filled surface is easy to sand and produces a smooth finish. The product has excellent filling properties and is suitable for spot repairs as well as full-surface application in indoor areas with high humidity. Suitable for leveling small cracks, fissures, unevenness, screw heads, and other minor imperfections on walls and ceilings.
• Maximum particle size: 0.15 mm
• Maximum layer thickness: 5 mm
• Color: white
• Coverage: 1 m²/L for a 1 mm-thick layer of full-surface application. Coverage depends on the application method and the substrate
• Solvent: water
• Drying time: 2–24 hours at 20°C and 50% relative humidity. Drying time increases at lower temperatures, higher humidity, and with thicker layers of filler.
• Tools: putty knife
• Cleaning tools: Remove dried putty from tools and wash them with water and soap immediately after application.
Surface preparation: The surface to be filled must be dry and free of loose or flaking material, grease, oil, dust, and other contaminants. If necessary, use Biotol E or Biotol Spray to remove mold. For filling cracks up to 10 mm, first use Face Filler, then perform the final smoothing with Aqua Filler. Prime porous, absorbent surfaces with Aquastop or Aquastop Bio. Sand surfaces previously coated with enamel or oil-based paints until they become matte.
Filling: Apply the filler to the surface using a putty knife. Apply a second coat of filler to the surface after the first coat has completely dried. Sand the dried surface with fine-grit sandpaper (No. 150–180) until smooth. Carefully remove any sanding dust. Suitable conditions for filling are an air and surface temperature of +10 to +25°C and relative humidity below 80%. Avoid drafts and high temperatures (above 25°C) during application. The filled surface can be painted or wallpapered after it has dried.
Storage: Store in the tightly sealed original container at a temperature of +5°C to +30°C. Protect from cold and direct sunlight.
Health and Safety Precautions: Wear a dust mask and safety goggles when sanding the filled surface. Avoid contact with skin and eyes. In case of contact with eyes, rinse thoroughly with water. Keep out of reach of children. Always handle paint products with care. Do not pour into sewers, waterways, or onto the ground. Avoid or minimize the generation of waste. Unused product is considered general waste but is not suitable for disposal with regular household waste and requires special handling; liquid residues must be handed over to a waste management company licensed to handle them.