Eskaro Face Filler is a ready-to-use, moisture-resistant lightweight putty for interior and exterior use. It adheres well to the substrate, dries quickly, and can be easily applied in thick layers (up to 10 mm). It does not contain cement. The product has excellent filling properties and is suitable for spot and base filling: leveling cracks, holes, and other irregularities on walls and ceilings.
• Maximum particle size: 0.25 mm
• Maximum layer thickness: 10 mm
• Color: light gray
• Coverage: 1 m²/L for a 1 mm base coat. Coverage depends on the application method and the substrate
• Solvent: water
• Drying time: 2–24 hours at 20°C and 50% relative humidity. Drying time increases at lower temperatures, higher humidity, and with thicker layers of filler.
• Tools: putty knife
• Cleaning tools: Remove dried putty from tools and wash them with water and soap immediately after application.
Surface preparation: The surface to be filled must be dry and free of loose or flaking material, grease, oil, dust, lichen, and other contaminants. If necessary, use Biotol E or Biotol Spray to remove mold. For complete removal of old coatings and heavy soiling, we recommend using pressure washing or sandblasting. Clean fixtures and other metal elements of rust and immediately prime them with rust-preventive paint. Prime porous, absorbent surfaces with Aquastop, Aquastop Bio, Aquastop Façade, or Tiefgrund. Sand surfaces previously coated with enamel or oil-based paints until they are matte.
Filling: Apply the filler to the surface using a putty knife. Apply a second coat of filler after the first coat has completely dried. Sand the dried surface until smooth, and carefully remove any sanding dust. Suitable conditions for filling are air and surface temperatures of +5...+25°C and relative humidity below 80%. During filling, avoid drafts, extreme temperatures (both high and low), rain, and fog. The filled surface can be painted or wallpapered after it has dried.
Storage: Store in the original, tightly sealed container at a temperature of +5°C...+30°C. Protect from cold and direct sunlight.
Health and Safety Precautions: Wear a dust mask and safety goggles when sanding the filled surface. Avoid contact with skin and eyes. In case of contact with eyes, rinse thoroughly with water. Keep out of reach of children. Always handle paint products with care. Do not pour into sewers, waterways, or onto the ground. Avoid or minimize the generation of waste. Unused product is considered general waste but is not suitable for disposal with regular household waste and requires special handling; liquid residues must be handed over to a waste management company licensed to handle such materials.