Eskaro Fine Pro Filler is a ready-to-use, fine-grained lightweight putty for interior use. Thanks to the lightweight filler used in its formulation, the putty is light and easy to apply to the surface. It adheres well to the substrate, dries quickly, and leaves a smooth finish that is very easy to sand. The product has good filling properties and is suitable for spot and full-surface application in dry indoor environments. It is suitable for leveling small cracks, unevenness, and other minor defects on walls and ceilings.
• Maximum particle size: 0.1 mm
• Maximum layer thickness: 2 mm
• Color: white
• Coverage: 1 m²/L for a 1 mm layer of continuous application. Coverage depends on the application method and the substrate
• Solvent: water
• Drying time: A 1 mm layer dries in 0.5–6 hours at 20°C and 50% relative humidity. At lower temperatures, higher humidity, and with a thicker layer of filler, the drying time will be longer.
• Tools: putty knife
• Cleaning tools: Remove dried putty from tools and wash them with water and soap immediately after application.
Surface preparation: The surface to be filled must be dry and free of loose or flaking material, grease, oil, dust, and other contaminants. If necessary, use Biotol E or Biotol Spray to remove mold. For filling cracks up to 10 mm, first use Face Filler; perform the final smoothing with Fine Pro Filler. Surfaces previously coated with enamel or oil-based paints should be sanded until matte. Prime porous, absorbent surfaces with Aquastop or Tiefgrund.
Filling: Apply the filler to the surface using a putty knife. Apply a second coat of filler after the first coat has completely dried. Sand the dried surface with fine-grit sandpaper (No. 150–180) until smooth. Carefully remove any sanding dust. Suitable conditions for filling are an air and surface temperature of +10...+25°C and relative humidity below 80%. Avoid drafts and high temperatures (above 25°C) during application. The filled surface can be painted or wallpapered after drying. Not suitable for damp rooms.
Storage: Store in the tightly sealed original container at a temperature of +5°C to +30°C. Protect from cold and direct sunlight.
Health and Safety Precautions: Wear a dust mask and safety goggles when sanding the filled surface. Avoid contact with skin and eyes. In case of contact with eyes, rinse thoroughly with water. Keep out of reach of children. Always handle paint products with care. Do not pour into sewers, waterways, or onto the ground. Avoid or minimize the generation of waste. Unused product is considered general waste but is not suitable for disposal with regular household waste and requires special handling; liquid residues must be handed over to a waste management company licensed to handle them.