Knauf Fill & Finish Light is a ready-to-use, air-drying, universal joint compound for indoor use. It consists of calcium carbonate, fillers, additives, and a polymer binder. It is suitable for filling joints in gypsum board, gypsum board surfaces, and various mineral substrates, such as plaster, concrete, aerated concrete, and brickwork. The joint compound has a soft consistency, is very easy to apply, and is simple to sand. It contains additives that improve adhesion and workability. Thanks to its lightweight formulation, the joint compound provides significant material savings (approx. 35%) during application. When filling a surface (for a 1 mm layer thickness), material consumption is approx. 1.1 kg/m².
Surface Preparation: The substrate must be dry, load-bearing, sound, level, and clean. Remove any existing material residues that may interfere with adhesion, such as paste, paper scraps, etc. Gypsum boards must be securely fastened to the substructure; furthermore, the boards must be dry and clean, including joints free of dust. Fill larger surface defects with Knauf Uniflott gypsum filler. For a smooth finish, the filled board joints must be dry and flush with the surface of the gypsum board.
Mixing: Thoroughly mix the joint compound in the bucket; if necessary—for example, when using a joint compound sprayer—thin it with a small amount of water—up to 1 liter of water per 20 kg bucket. Use clean mixing containers and tools. Do not mix the joint compound with other materials.
Tools: Jointing trowel, finishing trowel, screw-tip jointing trowel, wide jointing trowel, or Knauf jointing and corner finishing tool. To apply with a roller, choose a paint roller large enough to fit completely into the bucket of joint compound. Clean tools immediately with water after use.
Filling Gypsum Board Joints: Fill the joints with joint compound, place joint tape over the joints on the surface of the compound, and press it firmly against the compound by sliding the putty knife from top to bottom. Do not cover the paper tape with joint compound before it dries. Before applying subsequent layers of joint compound, the previous layer must be set and dry. Re-apply joint compound over the joints and around the fasteners. The putty cures as it dries; the curing time depends on humidity and room temperature. The temperature of the material, substrate, and ambient air must not fall below +10°C during application and until the putty is completely dry.
Storage: Protect from cold, high temperatures, and direct sunlight. Store at room temperature for at least 12 months.