Sadolin Maxi Pro Light is a ready-to-use, lightweight, fine-grained interior putty. Thanks to its creamy consistency, the putty is easy to apply to the surface. The product’s good workability and minimal shrinkage simplify the filling of even large surfaces. The dried putty surface is very easy to sand. The maximum thickness per coat is 2 mm. The product is intended for filling walls and ceilings in dry rooms. It is suitable for spot-filling individual holes and irregularities as well as for full-surface application on larger areas, and for filling drywall joints and installing joint tape. Suitable for filling plasterboard, stucco, concrete, lightweight concrete, and brick surfaces.
• Application: dry indoor areas
• Binder: copolymer
• Particle size: max 0.10 mm
• Density: ~ 1.0 kg/l
• Drying time: (23°C, RH 65%) ~ 3–4 hours for a 1 mm layer of filler
• Coverage: (1 coat) up to 2 mm
• Thinner: The putty has a consistency suitable for application to the surface and does not require thinning
• Color: light beige
• Tools: putty knife
• Cleaning tools: with water immediately after use
• Storage: Store in a sealed container in a dry and cool place (above +5°C); protect the product from freezing
Surface preparation: The scope of work required depends on the specific condition of the surface and the requirements for it. The substrate must be dry and free of dust, dirt, and grease. Remove old, loose paint and weakly adhered surface layers down to a sound substrate. Use lukewarm or warm water to clean previously painted surfaces; use a detergent to clean heavily soiled surfaces. Completely remove any old wallpaper that is loose or poorly adhered to the surface. Sand surfaces previously coated with glossy paint with sandpaper to improve adhesion.
Filling: The filler is ready to use. After prolonged storage, the product may require light stirring. Do not mix other types of fillers or dry mixes into the product. Apply the filler to the surface in one or more layers up to 2 mm thick. Before applying the next layer of filler, ensure that the previous layer has dried. Smooth the fresh putty on the surface as evenly as possible to minimize the amount of sanding required later. Reinforce joints and wider cracks with paper or fiberglass tape. Use fine-grit sandpaper (grit 150–180) to sand the filled surface. After sanding, remove any sanding dust from the surface. Latex, alkyd, and acrylic paints are all suitable for painting the filled surface.
Storage: Store in a sealed container in a dry and cool place (above +5°C); protect the product from freezing.
Health and Safety Requirements: When applying the putty and sanding the surface, follow all safety precautions; use a respirator, wear eye or face protection, and ensure the work area is well ventilated. When finished, carefully seal the putty container. Remove excess putty before cleaning tools. Do not pour the product down the drain or into bodies of water. Dispose of liquid putty residues at a collection point for hazardous materials; only completely emptied containers should be sent for waste disposal.