Mira 3230 SuperRapidFix is a white, cement-based, cold- and water-resistant, polymer-reinforced tile adhesive for walls and floors, for indoor and outdoor use, in damp and dry rooms on substrates with moderate deformation. A tile adhesive with a very wide range of applications that meets the requirements of most different substrate types and tile types. Particularly well-suited when a short drying time is essential. A dry mix that is ready for use after mixing with water. The tile adhesive is easy to prepare and simple to apply to the surface.
Applications:
For installing all types of ceramic tiles, clinker tiles, and natural stone on walls and floors, indoors and outdoors, in dry and damp areas.
Particularly suitable for installing on heated floors, as well as for glass mosaics, thin semi-transparent tiles, marble, and similar materials.
Substrate:
Floors and walls with moderate deformation, such as plastered masonry, stone walls, gypsum board, gypsum plaster, concrete elements, and lightweight concrete elements with moderate volume expansion.
Substrate Preparation
The substrate must be load-bearing, stable, free of cracks, and clean of dust, grease, and cement slurry. The surface should be dry enough for the mira 4180 primer to be absorbed.
When installing on old tiles or painted surfaces, ensure that the tiles and paint are firmly adhered. Clean the surface using mira 7110 base cleaner.
Prime absorbent surfaces with 4180 primer, and make damp rooms watertight in accordance with ETAG 022 regulations and Mira’s instructions.
Directions
: Mix 15 kg of powder with 3.75–4.2 L of clean water to form a homogeneous mixture; the mixture is then ready for use. For best results, use a mixer. The powder, water, and substrate must be within the recommended working temperature range. The tile adhesive must be used within 30 minutes after mixing. It is not recommended to apply the mixture to larger surfaces than can be covered with tiles before a skin forms.
Spread 3230 SuperRapidFix onto the surface and smooth it out with the straight edge of a trowel, then comb through it with the notched edge. Select the appropriate trowel based on the tile type. Press the tiles into the wet mixture. Ensure that the back of the tile is completely covered with the mixture.
For complex structures such as porches, facades, swimming pools, etc., the mortar must be applied to both the substrate and the tile to achieve 100% coverage.
Surfaces larger than 36 m² or with a side longer than 8 m are typically divided into separate work sections throughout the entire structure.
Depending on the absorbency of the tiles and the room temperature, the surface is ready for further processing in approximately 1–2 hours.
• Coverage on walls and floors (average): 2.5 kg/m², 3.5 kg/m²
• Pot life when ready-mixed: up to 30 min
• Recommended application temperature: 10–20 °C
• Drying time: for further processing / light traffic 1–2 h; for full load 24–30 h