Sakret BAK is a gray reinforcing and adhesive mixture / leveling compound used in exterior and interior applications for reinforcing and bonding expanded polystyrene and mineral wool thermal insulation boards. It is also suitable for thin-layer leveling of mineral surfaces.
BAK is cement-based and contains reinforcing fibers as well as additives that improve adhesion and elasticity. Water- and frost-resistant. High water vapor permeability. Can be applied by hand or with a pump.
A component of the ETICS SAKRET EPS (ETA-10/0064) and ETICS SAKRET MW (ETA-10/0185) thermal insulation composite systems.
Substrate Preparation
The surface must be clean, sound, level, and dry. Fill cracks and holes. Old masonry and plaster surfaces must be cleaned with a sandblaster or high-pressure water jet.Remove flaking plaster and peeling paint; clean oily or other surfaces that prevent adhesion. Sand expanded polystyrene boards beforehand with sandpaper. Prime the substrate surfaces with Sakret TGW, UG, BG, or QG primer, depending on the material.
Application Procedure
Mix the dry mix with clean, cold water using a mixer (600 rpm) until a uniform, lump-free consistency is achieved. Let the mixture stand for 3 minutes, then mix again. Do not add water to a mixture that has begun to set! When using as an adhesive mixture, follow the application instructions for Sakret BK. When reinforcing insulation boards, apply the mixture to the surface using a notched trowel or plaster pump, press the fiberglass reinforcement mesh into the wet mixture, and level the surface. Apply a second layer of the mixture over the set or hardened layer and level it. To fill mineral surfaces, apply the mixture to the surface using a notched trowel or plastering pump and level it. For layers thicker than 3 mm, it is recommended to use glass fiber reinforcement mesh to prevent cracking. Not suitable for overplastering lime plaster or weak plasters. The temperature of the substrate and the ambient air during application must be at least +5°C to +25°C.
• Frost resistance class: F
50• Aggregate particle size: up to 0.5 mm•
Coverage for bonding/reinforcement: approx. 4–8 kg/m²•
Fire resistance class: A1 (non-combustible)
• Adhesion strength: ≥1.4 N/mm²•
Compressive strength: plaster class CS
III• Composition: Cement, special inert additives, microfibers, fillers,
additives to improve workability• Shelf life: 12 months from
the date of manufacture• Compliance with standard, system: EVS-EN 998-1:2011, ETAG-004