Sakret BK is an adhesive mixture made of expanded polystyrene and mineral wool for bonding thermal insulation boards in exterior and interior applications. It is also suitable for bonding gypsum boards in interior applications.
The cement-based BK is water- and frost-resistant, has high water vapor permeability, and is gray in color. Can be applied by hand or with a pump.
A component of the ETICS SAKRET EPS (ETA-10/0064) and ETICS SAKRET MW (ETA-10/0185) thermal insulation composite systems.
Substrate Preparation
The surface must be clean, load-bearing, level, and dry. Fill cracks and holes. Old masonry and plaster surfaces must be cleaned with a sandblaster or high-pressure water jet. Remove flaking plaster and peeling paint; clean oily or other surfaces that prevent adhesion. Prime the substrate with Sakret TGW, UG, BG, or QG primer, depending on the material.
Application Procedure
Mix the dry mix with clean, cold water using a mixer (600 rpm) until a uniform, lump-free consistency is achieved. Let the mixture stand for 3 minutes, then remix. Do not add water to a mixture that has begun to set! On level substrates, apply the mixture using a notched trowel (with teeth at least 10 mm long) in an even layer over the entire bonding surface of the insulation board. For surfaces with unevenness, apply the mixture as a 5 cm wide and at least 2 cm high bead of mortar to the back of the board to form a continuous bead around the entire perimeter of the board. Apply up to 6 m of mortar to the center of the ring. Ensure that the contact surface covered with the mixture constitutes at least 40% of the total surface area of the EPS board and 50% of the total surface area of the mineral wool board. Press the panel into place, ensuring that the adhesive does not enter the joints between the panels during pressing. The temperature of the substrate and the ambient air during application must be between at least +5°C and +25°C.
• Coverage: approx. 4–8
kg/m²• Fire resistance class: A1 (non-combustible)
• Tensile bond strength: ≥0.5
N/mm²• Filler particle size: up to 1 mm•
Compliance with standard, system: EVS-EN 12004:2011,
ETAG-004• Shelf life: 12 months from the date of manufacture