Mira 3110 unifix is a white, cement-based, cold- and water-resistant, polymer-reinforced tile adhesive for floors and walls, for indoor and outdoor use, in dry and damp rooms on stable substrates. Particularly suitable for installing absorbent tiles on stable substrates with minimal deformation. A dry mix that is ready for use after mixing with water. The tile adhesive is easy to prepare and simple to apply to the surface.
Applications:
For installing all types of ceramic tiles, clinker tiles, and natural stone indoors and outdoors, in dry and damp areas. Also suitable for heated floors.
Substrate
: Stable walls and floors with minimal deformation, such as plastered brick, stone walls, gypsum boards, concrete elements, and lightweight concrete elements with minimal volume expansion.
Substrate Preparation
The substrate must be load-bearing, stable, free of cracks, and clean of dust, grease, and cement slurry. The surface must be dry enough for the mira 4180 primer to be absorbed. Prime absorbent surfaces with 4180 primer, and waterproof damp areas in accordance with ETAG 022 guidelines and the mira instructions.
Application
: Mix 25 kg of powder with 6.25–7 L of clean water to form a homogeneous mixture; the mixture is then ready for use. For best results, mix with a concrete mixer. The powder, water, and substrate must be within the recommended working temperature range. The tile adhesive must be used within 6 hours after mixing. It is not recommended to apply the mixture to large areas unless the tiles can be laid before a skin forms.
Apply 3110 unifix to the surface using the straight edge of a trowel, then comb through with the notched edge. Select the trowel based on the type of tile. Press the tiles into the wet mortar. Ensure that the back of the tile is completely covered with the mixture.
Surfaces larger than 36 m² or with sides longer than 8 m are typically divided into separate work sections throughout the entire structure. Depending on the absorbency of the tiles and the room temperature, the surface is ready for further treatment after approximately 10 hours on walls and 18 hours on floors.
• Coverage on walls and floors (average): 2 kg / m², 3 kg / m²
• Pot life when ready-mixed: up to 6 h
• Recommended application temperature: 10–25 °C
• Drying time: for further processing / light traffic 10–24 h