Applications: This product is suitable for use on subfloors to achieve the desired height and to fill the space between joists. To ensure strength, the surface of the poured EPS light concrete must always be covered with the mira self-leveling mixture. Information on this can be found in the relevant publication. The mira EPS Light Concrete 360 subfloor is suitable for use on concrete floors as well as on floors constructed from building panels laid over wooden joists, where minor deformations may occur. Substrate Preparation Clean the substrate of dirt and dust. If the mira EPS Light Concrete 360 pour is installed on a stable substrate, the substrate must be primed using mira 4180 primer. If the EPS lightweight concrete is installed on a wooden surface, the substrate must be covered with a moisture-proof barrier (such as plastic sheeting or vapor barrier paper). Mix 50 liters of dry mix with 7.5–9.5 liters of water, depending on whether the product is applied by hand or pumped. The mixed mixture must be used within approximately 1 hour. Apply the mixture to the substrate, compact it lightly, level it to the desired height using a screed, and smooth it with a trowel. The layer thickness must be at least 15 mm on a stable substrate and at least 30 mm for a floating floor.
It is advisable to protect a freshly installed floor screed from drying out too quickly by covering the surface with plastic sheeting, for example. Depending on the air temperature and humidity,
the surface will be ready for covering with a leveling compound after 20–30 hours.