Sakret MRP is a white, mineral-based decorative plaster with a rain- or pebble-like texture and a grain size of 2 mm. Suitable for both interior and exterior use. This white cement- and lime-based plaster can be used as a finishing coat for facades insulated with either mineral wool or EPS.
MRP can be painted over and tinted with mineral dry pigments. Highly vapor-permeable and non-combustible. The product has high vapor permeability.
A component of the SAKRET EPS (ETA-10/0064) and SAKRET MW (ETA-10/0185) ETICS thermal insulation composite systems.
Substrate Preparation
The surface must be clean, level, and dry. Fill cracks and holes. Remove flaking plaster and peeling paint; clean oily or other surfaces that prevent adhesion. Prime the substrate with Sakret PG primer. The primer can be tinted to match the color of the paint intended for the plaster coating.
Work Procedure
:
Mix the plaster in a clean container with clean, cold water until a lump-free consistency is achieved, and repeat mixing after 5 minutes. To tint the plaster with dry pigments, follow the instructions in the Sakret dry pigment user manual. Apply the plaster to the surface with a stainless steel trowel, level it, and spread it out with a plastic float using circular, vertical, or horizontal motions. Avoid direct sunlight on the surface being plastered during application. The plaster’s drying time (dust-dry) is approximately 30 minutes; it is rainproof after at least 24 hours. Optimal substrate and ambient temperatures during application are +5°C to +25°C; avoid temperatures higher than +30°C and sub-zero temperatures. The plaster can be painted over with Sakret KS, FM, SKF, and FC exterior paints; indoors, it can be painted over with all Sakret interior paints.
• Compliance with standard: EN 998-1:
2011• Coverage: 3.0 kg/m²•
Fire safety class: A1 (non-combustible)
• Shelf life: 12 months in unopened original packaging