Weber VH is a cement-based finishing mix for dry, damp, and wet areas, as well as outdoor use. It is used for finishing ceilings and walls, and as a finishing layer serving as a base for exterior wall paint. When mixed with water, it forms a ready-to-use skim coat that, once set, is moisture- and frost-resistant. Suitable for skimming concrete, brick, and plastered walls. The skim coat is heat- and water-resistant.
• Coverage: approx. 1.2 kg/m²/1 mm
• Application temperature: at least +10°C
• Shelf life: 12 months (in dry conditions, in unopened original packaging)
• Drying time (touch dry): 1–2 days, depending on layer thickness, temperature, and ventilation
• Mix layer thickness: 1 mm for full leveling; partial leveling up to 3 mm
• Water content during mixing: 8 l/25 kg (26%)
• Compressive strength at 28 days: 6–8 MPa (EN 1015-11)
• Binder: cement
• Filler: limestone powder, particle size < 0.3 mm
• Pot life: 4 hours after adding water
• Color: white
Surface preparation: The substrate must be clean, sound, and free of dust. Remove any substances that could impair adhesion, such as paint, grease, dust, etc., from the substrate. Windows and other surfaces that are not to be leveled must be carefully covered.
Mixing: Use only clean, room-temperature water—approximately 8 liters per 25 kg of dry mix. Mix in two stages using a mixer attachment. The first mixing is done with less water, and the mixture is allowed to stand for about 10 minutes. Mix lightly a second time and add the remaining water. The pot life of the finished mixture is up to 4 hours after adding water. The temperature of the prepared mixture must exceed +10°C.
Partial Leveling: If necessary, dry and porous surfaces should be moistened before starting work. For partial leveling, apply the putty to the surface by hand using a putty knife of suitable width.
Full-surface leveling: For full-surface leveling, use a 60–80 cm-long trowel or a plaster sprayer. Excess mixture is removed to the mixing bucket and reused later. Before applying the next layer, the previous layer must be completely set (1–2 days). Sand each layer with fine-grit sandpaper. In dry conditions, the surface must be moistened afterward.
Surface Treatment: The set surface can be painted, wallpapered, or covered with ceramic tiles. Surfaces leveled with Weber VH can also be left unfinished (e.g., as a sprayed surface for a final finish).
Cleaning Tools: Wash tools with water immediately after use. Avoid allowing mixture residues to enter the sewer system.
Safety Precautions: Causes irritation. Contains more than 5% cement by total volume. Irritates the eyes, respiratory tract, and skin. Avoid prolonged skin contact. If necessary, wear safety goggles, a respirator, gloves, or protective cream. Avoid inhaling dust. If the mixture gets into your eyes, rinse immediately with plenty of water and consult a doctor if necessary.