Weber LR+ is a polymer-modified finishing plaster for dry indoor areas. Suitable substrates include cement-based plasters and fillers (e.g., Weber TT, Weber L), gypsum plasters, and gypsum board walls and ceilings. Weber LR+ can be used to skim-coat structures made of wood-chipboard or porous fiberboard. Add water to create a ready-to-use skim coat. The average application thickness is 1–2 mm. It can be applied either by hand or with a skim coat pump.
• Coverage: approx. 1.2 kg/m²/1 mm
• Application temperature: at least +10°C
• Shelf life: 18 months (in dry conditions, in the original sealed packaging)
• Drying time (touch dry): 1–2 days, depending on layer thickness, temperature, and ventilation
• Mixture layer thickness: 1–2 mm for full leveling; partial leveling up to 3 mm
• Water content when mixing: 8–9 L/25 kg
• Binder: polymer adhesive
• Filler: limestone powder, particle size < 0.3 mm
• Pot life: 2–3 days when ready-mixed in a sealed container
• Color: white
Surface preparation: The substrate must be clean, solid, and free of dust. Remove any substances that could impair adhesion, such as paint, grease, and dust. Windows and other surfaces that will not be plastered must be carefully covered.
Mixing: Use only clean water at room temperature for mixing. Water consumption: 8–9 liters per 25 kg. Mix twice using a mixer attachment. The first mixing (approx. 2–3 minutes) is done with less water, after which the mixture is allowed to stand for approx. 15 minutes. Mix a second time (approx. 2–3 minutes) gently and add the remaining water. The temperature of the finished mixture must exceed +10°C. The prepared putty is usable for 2–3 days when stored in a sealed container (e.g., after use, pour a layer of water approximately 5 cm thick over the putty so that the entire surface is submerged; before the next use, pour the water off the putty and remix it).
Application: If necessary, moisten dry and porous surfaces before starting work. For spot leveling, apply the finishing mixture to the surface by hand using a trowel. For large-area leveling, the mixture can be applied to the surface either with a plaster sprayer or by hand using a wide trowel. When using a trowel sprayer, apply the mixture to an area large enough to be smoothed with a trowel within approximately 10–20 minutes. Remove excess mixture from the trowel into the mixing bucket and reuse it later. The previous coat must be dry before applying the next one. Use fine-grit (120–180) sandpaper for sanding.
Surface Finishing: The set surface can be painted or wallpapered. Surfaces filled with Weber LR+ may also be left unfinished (e.g., as a sprayed finish on ceilings).
Cleaning tools: Clean tools with water immediately after use. Avoid allowing mixture residues to enter the sewer system.
Safety precautions: Plaster dust irritates the eyes, respiratory tract, and skin. If necessary, wear safety goggles, a respirator, gloves, or protective cream. Avoid inhaling dust. In case of skin irritation, wash immediately with warm soapy water. If the mixture gets into your eyes, rinse immediately with plenty of water and consult a doctor if necessary.