The Tycroc UHP underfloor heating base plate was developed to simplify and speed up the installation of hydronic underfloor heating, allowing it to be installed without the need for concrete pouring. Tycroc UHP is also suitable for installation on concrete structures, but thanks to its low weight per square meter, the solution offers particular added value for wood structures and wooden buildings. Extruded polystyrene foam (XPS foam), which features channels specifically cut for heating pipes, prevents heat from escaping downward, and the 0.1 mm (100 µm) thick aluminum foil serves as an effective heat distributor beneath floor covering materials.
Tycroc UHP is suitable for installation on all common load-bearing subfloors, eliminating the need for costly and time-consuming casting work. Installation is simple, fast, and clean, and requires no additional curing time (unlike concrete pouring, for example). It responds quickly to temperature adjustments—since the system allows flooring to be installed directly over Tycroc UHP panels, heat is dissipated more quickly and efficiently due to the shorter distance between the heating pipes and the flooring material, as well as the lower thermal mass—meaning the solution offers real potential for heating cost savings. With a poured concrete solution, the thermal inertia is high (12–24 hours in some cases), which in practice precludes energy savings through continuous regulation of the indoor temperature. A room temperature that is 1°C lower results in approximately 5% energy savings. During the day, people are usually away from home, and the indoor temperature can generally be lower at night as well; therefore, there is a clear need for relatively frequent temperature adjustments, and the potential for energy savings is definitely present. The recommended heating water temperature in the pipes is 35–40 °C. Compared to traditional, material-intensive solutions, our solution is also significantly lighter (the panel weighs only about 1.3 kg/m² or 1.6 kg/m²) and has a lower installation height (panel thickness 25 mm or 30 mm). The XPS panel has excellent thermal insulation properties, thereby providing additional insulation for floors where thermal insulation is insufficient or entirely absent. The base material of Tycroc UHP, XPS, is closed-cell and waterproof, making the product well-suited for constructing floors in wet areas.
This solution is suitable for both renovation projects and new construction. Underfloor heating base panels can be installed on any load-bearing subfloor that is level, dry, strong, rigid, and stable. If a floating floor covering is to be installed later, Tycroc UHP panels can also be fastened to a wooden subfloor using wood screws and Tycroc fastening washers; otherwise, use a tile adhesive or mortar suitable for the subfloor and for bonding the plastic covering.
Tycroc UHP is suitable for use under all common floor coverings, including parquet, wood, ceramic floor tiles, or natural stone. If necessary, Tycroc UHP can be covered with concrete or gypsum screed and various prefabricated dry-floor elements, including gypsum fiberboard, cement fiberboard, or gypsum board. Parquet, laminate, and wood flooring are installed (along with the parquet underlayment) directly on top of Tycroc UHP as a floating floor, while ceramic floor tiles and natural stone are bonded using an appropriate tile adhesive.