Weber.tec 822 is a single-component, ready-to-use waterproofing compound for walls and floors, used as a waterproofing base for tile installation in damp and wet areas: bathrooms, washrooms, shower rooms, saunas, and other damp areas. Weber.tec 822 is highly elastic, bridges cracks, and, thanks to its viscosity, provides excellent coverage. Weber.tec 822 is not suitable for use in swimming pools or areas subject to constant water pressure.
Weber.tec 822 is suitable for various substrates such as lime, lime-cement, and cement plaster, concrete, drywall, ceramic tile, etc. The product is very easy to work with, applies smoothly to the surface, and, thanks to its good elasticity, bridges minor cracks in the substrate. The substrate must be sufficiently strong, stable, clean, dry, and free of dust. Absorbent surfaces must first be treated with the webertec 811 adhesion primer, and non-absorbent substrates with the weberprim 804 primer. All substances and layers that prevent adhesion (dust, weak or damaged plaster, etc.) must be removed before work begins.
A wide brush, a broom, and a paint roller are suitable for applying the material (a trowel and putty knife may also be used). Waterproofing work must begin with thorough cleaning of the surfaces (using a vacuum cleaner). The cleaned surface is primed with the weberprim 811 adhesion primer to ensure strong adhesion to the waterproofing compound. To achieve a continuous and uniform waterproofing layer, first reinforce staircases, penetrations, and wall-to-wall and wall-to-floor corners. Weber FC fiberglass tape is used to seal internal and external corners. Pieces of fiberglass fabric cut from a roll of Weber FM can be used to seal steps and penetrations. Before installing the fabric, apply the weber.tec 822 waterproofing compound to the substrate and press the fabric into it, ensuring that no air bubbles remain trapped beneath the fabric. Then, apply another layer of the waterproofing compound over the installed fiber-reinforced fabric. A long-pile paint roller is the most suitable tool for applying liquid waterproofing. To ensure the applied layer is sufficient and continuous, the work must be carried out in two layers, and it is better to apply a slightly larger amount of material to the surface to ensure sufficient layer thickness after drying (do not apply less than the minimum coverage rate of approx. 1.0–1.2 kg/m²). Since the waterproofing compound is elastic and water-repellent, an elastic tile adhesive with high bonding strength (e.g., weber Extra Fix) must be used for tiling.