Mira Classic cement-based grout for floors and walls, for indoor and outdoor use, in wet and dry areas, for joint widths of 2–15 mm.
Applications
:
For grouting tiles and ceramic clinker on floors and walls, indoors and outdoors, in wet and dry areas. Joint width: 2–15 mm.
The
Classic type
is suitable for grouting all types of ceramic tiles and natural stone.
Surface Preparation
:
Joints and tiles must be clean and free of dust, oil, dirt, grease, etc.
Application
:
Mix 15 kg of powder with 3.4–3.5 L of clean water. For best results, mix with a slow-speed mixer to prevent air from entering the mixture. The powder, water, and substrate must be within the recommended working temperature range. Mix for 2–3 minutes until a smooth, lump-free paste is formed. The mixture is now ready for use within 3–4 hours after preparation. Press the grout into the joints using a rubber trowel with diagonal strokes. Once the grout begins to set but is not yet hardened, remove excess grout with a damp washcloth or a rubber squeegee. Clean the tile surface and smooth out the joints with a damp washcloth or washboy. Finish the surface, remove any water, and wipe away any remaining grout. Keep the joints moist for 2 days to prevent them from drying out too quickly. After about two days, any hardened grout residue can be removed with 7120 Ceramic Cleaner. Depending on the porosity of the tile and the room temperature, the grouted surface can withstand light foot traffic after 24 hours and full load after 7 days.
Safety Precautions
: This product contains cement; follow safety guidelines for working with cement. The product is made from white cement, which naturally has a very low hexavalent chromium content, always remaining below the permitted limit of 2 mg/kg. See also the safety data sheet.
Packaging
:
15-kg paper bags with handles.
Storage and Transport
:
Transport and store in a dry and cool place. The product’s technical properties are maintained for at least 12 months from the date of manufacture when stored in unopened packaging. The product can be used beyond this period; however, a longer storage period may cause changes in properties, such as an increase in setting time.