Eskaro Face Filler is a ready-to-use, moisture-resistant lightweight filler for interior and exterior applications.
Good filling properties
Good adhesion to
the substrate Contains reinforcing fibers
Easy to apply in thick layers
(up to 10 mm) Suitable for base coating and filling
larger irregularities Cement-free
Moisture-resistant
Coverage: 1 m²/L when applied in a 1 mm layer. Coverage depends on the application method and the substrate.
Drying time: A 1 mm layer dries in 2–4 hours at a temperature of +23°C and 50% relative humidity. At lower temperatures, higher humidity, and with thicker application layers, the drying time increases and may extend to several days.
Maximum layer thickness: 10 mm
Maximum particle size: 0.25 mm
Applications
Spot and base filling for interior and exterior applications. Suitable for leveling cracks, holes, and other irregularities on walls and ceilings.
Surfaces
to be filled
: Concrete, gypsum, gypsum board, plaster, stone, and other mineral surfaces for interior and exterior use.
Surface Preparation
The surface to be filled must be dry and free of loose or flaking material, grease, oil, dust, lichen, and other contaminants. If necessary, use Biotol E or Biotol Spray to remove mold (follow the product’s instructions for use). For complete removal of old coatings and heavy soiling, we recommend using pressure washing or sandblasting. Clean fixtures and other metal elements of rust and immediately prime them with rust-inhibiting primer. Prime porous, absorbent surfaces with Aquastop, Aquastop Bio, Aquastop Facade, or Tiefgrund (follow the product instructions). On previously painted surfaces, remove old, peeling paint using a brush, scraper, heat gun, or the OPS Pro paint remover. Sand highly glossy surfaces until they become matte. Carefully remove all sanding dust.
Filling
: Stir thoroughly before use. Apply the filler to the surface with a putty knife. Suitable conditions for filling are an air and surface temperature of +10…28 °C and relative humidity below 80%. During filling, avoid drafts, extreme temperatures (both high and low), rain, and fog. Apply the next layer of filler to the surface only after the previous layer has completely dried. Sand the surface immediately after drying. Carefully remove all sanding dust. For interior work, we recommend using Fine, Fine Pro, or Aqua Filler putties for the final finish.
Tools
:
Putty knife.
Cleaning
Tools:
Remove dried filler from tools and wash them clean with water and soap immediately after applying the filler.
Safety Precautions
: Contains 1,2-benzisothiazol-3(2H)-one, 2-methylisothiazol-3(2H)-one, a reaction mixture of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2H-isothiazol-3-one. May cause an allergic reaction. If you seek medical attention, take the product packaging or label with you. Keep out of reach of children.
Waste Management and Environmental
Protection
Paint products must always be handled with care. Do not pour down the drain; prevent release into the environment. Avoid or minimize the generation of residues. Unused product is considered general waste but is not suitable for disposal with general waste and requires special handling; liquid residues must be handed over to a waste management company with an environmental permit for disposal (Waste code 08 01 12, paint and varnish waste containing organic solvents or other hazardous substances; 08 01 11). Information about waste management companies is available from your local government or the Environmental Board. Dried residues may be disposed of in a household waste container. (Waste management code 15 01). Take empty, dry packaging to a packaging waste collection point for recycling. Returnable packaging must be thoroughly cleaned before being sent for recycling. For larger quantities, contact the Estonian Recycling Organization MTÜ, eto@eto.ee
Storage
Conditions
Store in the tightly sealed original packaging at a temperature of +5…30°C. Protect from cold and direct sunlight.