The drinking fountain has three flow modes: spray, waterfall, and basin. The larger water surface area of the elongated drinking basin reduces competition among cats at the drinking station, making the fountain suitable for homes with multiple cats. There is no physical contact between the pump and the power base, as the circuit board is enclosed within the housing. The power base’s control unit has an IPX4 protection rating, meaning it is protected against water splashes from any direction. The filter system traps particles, debris, cat hair, odors, and chlorine residues. The pump has a cotton pre-filter for added protection.
Install the pump, pump cover, and drinking station so that the water level sensor faces the inside of the tank. Place the main unit on the power base so that the base does not lift the tank. Run the power cord through the groove in the tank, connect it to the adapter, and plug the adapter into an outlet. No tools are needed for disassembly. Lift the main unit off the power base with both hands, tilt the fountain head, and remove the drinking base. Unscrew the fountain head counterclockwise from the drinking base and rinse the parts with clean water. Remove the filter cartridge cover and clean or replace the filter. Remove the pump and pre-filter, then remove the pump’s filter cartridge, impeller cover, and impeller one by one, and rinse them with clean water. Wipe the power base with a dry cloth. Finally, fill the tank with water up to the water level line, replace the drinking base, and place the tank on the power base. The manufacturer recommends cleaning the filter of floating hair every 3 days and the pre-filter every 10 days, and replacing both every 30 days. If the fountain is not used for an extended period, dry the filter.