You can switch the drinking fountain’s mode with a single press of the button. In continuous mode, a white light is on and water flows continuously. In Smart mode, a blue light is on and water flows for 20 seconds every 5 minutes. In Energy-Saving mode, a green light is on and water flows for 20 seconds every 30 minutes. A steady red light indicates a low water level; a flashing red light reminds you to replace the filter, which you can reset by pressing the button twice. The tank is semi-transparent, so you can see the water level from the outside. According to the manufacturer, the operating noise is up to 30 dB.
The filter consists of a stainless steel mesh, non-woven fabric, ion-exchange resin, and activated carbon, and traps dust, hair, odors, and other impurities. The filter housing is reusable; only the filter cartridge needs to be replaced. The pump’s pre-filter keeps hair and debris out of the pump. The pump operates with a magnetic drive, so there are no electrical components in the drinking area. The drinking basin is made of 304 stainless steel.
Installation and use: Place the pre-filter in the pump housing and connect the pump to the silicone connector located under the filter holder. Fill the tank with clean water up to the MAX mark and place the filter holder on the tank. Unscrew the filter cartridge lid, insert the filter, screw the lid on tightly, and place the cartridge in the filter holder. Place the drinking tray on top, lift the assembled unit onto the base, and connect it to the power outlet using the included adapter. For backup power, unscrew the battery compartment cover on the bottom of the base and insert four AAA batteries.
Cleaning and Maintenance: Remove the drinking base, filter cartridge, filter holder, and pump in that order; unscrew the filter cartridge lid and clean each part with the brush included in the kit. The manufacturer recommends cleaning the tank at least once a week, performing a thorough cleaning once a month, and replacing the filter every 30 days. All parts except the base, adapter, and power cord can be washed with water; clean the base with a dry cloth.